Lenze L-force HighLine C 8400 Series Reference Manual page 370

8400 HighLine C | Reference manual
Technology applications
TA "Actuating drive speed"
Identifier
MCK basic functions
bMBrakeReleaseOut
bMBrakeReleased
GP: GeneralPurpose
The following outputs are interconnected with logic/arithmetic functions on application level for free usage.
"GeneralPurpose" functions
nGPAnalogSwitchInOut_a
nGPArithmetikOut_a
nGPMulDivOut_a
bGPDigitalDelayOut
bGPLogicOut
bGPCompareOut
bGPSignalOut1
...
bGPSignalOut4
nGPSignalOut1_a
...
nGPSignalOut4_a
bGPDFlipFlop_Out
bGPDFlipFlop_NegOut
Free outputs
The following outputs can freely be interconnected on the application level.
The signals from the application level can be transferred to the I/O level via these outputs.
bFreeOut1 ... bFreeOut8
wFreeOut1 ... wFreeOut4
370
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Value/meaning
Data type
Holding brake control: Trigger signal for the holding brake control switching
element via a digital output
BOOL
• Use bit 0 in C02582
FALSE Apply brake.
TRUE Release brake.
Holding brake control: "Brake released" considering the brake release time
• When the holding brake is triggered to close, bMBrakeReleased is immediately set
BOOL
to FALSE even if the brake closing time has not yet elapsed!
TRUE Brake released (when the brake release time has elapsed).
Analog switch: Output signal
INT
Arithmetic: Output signal
INT
Multiplication/Division: Output signal
INT
Binary delay element: Output signal
BOOL
Binary logic: Output signal
BOOL
Analog comparison: Output signal
BOOL
Binary signal monitor: Output signal
• The signal sources to be output are selected in C00411/1...4.
• A bit coded inversion of the output signals can be parameterised in C00412.
BOOL
Analog signal monitor: Output signal
• The signal sources to be output are selected in C00410/1...4.
• Gain and offset for each output signal can be parameterised in C00413/1...8.
BOOL
D-FlipFlop: Output signal
BOOL
D-FlipFlop: Negated output signal
BOOL
Free outputs for digital signals
BOOL
Free outputs for 16-bit signals
WORD
L
to activate inverted switching element triggering.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011