Control Mode "Mci - Lenze L-force HighLine C 8400 Series Reference Manual

11.2

Control mode "MCI"

"40: MCI" can be selected as a control mode in
drive controller control by means of MCI-PDOs via the fieldbus interface.
Given that the technology applications are fundamentally different and have different
requirements regarding the signals sent to them, predefined assignment of the MCI-PDOs
depends on the technology application selected in C00005:
 TA "Actuating drive speed":
Process data assignment for fieldbus communication
 TA "Table positioning":
Process data assignment for fieldbus communication
 TA "Switch-off positioning":
Process data assignment for fieldbus communication

Tip!
The predefined assignment of the MCI-PDOs can be parameterised by means of
PDO mapping and can be freely configured on the I/O level in the function block
editor (FB editor).
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
C00007 in order to quickly and easily set-up
( 380)
( 411)
( 437)
L
Fieldbus interface
Control mode "MCI"
689