Lenze L-force HighLine C 8400 Series Reference Manual page 710

8400 HighLine C | Reference manual
Parameter reference
Parameter list
Parameter | Name:
C00002 | Device command
C00002/14
C00002/15
C00002/16
C00002/17
C00002/18
C00002/19
C00002/20
C00002/21
C00002/22
C00002/23
C00002/24
C00002/25
C00002/26
C00002/27
C00002/28
C00002/29
C00002/30
710
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
0: Off / ready
0: Off / ready
1: On / start
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
0: Off / ready
L
Reserved
Reserved
Enable controller
"1" ≡ Enable controller
"0" ≡ Inhibit controller
Activate quick stop
"1" ≡ Activate quick stop
"0" ≡ Deactivate quick stop
Reserved
Reset error
• After the reset (acknowledgement) of the current
error, further errors may be pending which must also
be reset.
• The status determining error is displayed in C00168.
• The current error is displayed in C00170.
Reserved
Delete logbook
• All entries in the logbook of the controller are deleted.
• In the logbook, information on the error history is
saved.
Reserved
Motor parameter identification
• This device command serves to carry out automatic
motor parameter identification.
• The device command is only executed when the drive
controller is in the "SwitchedOn" status.
• In order to identify the motor parameters, the
controller must be enabled after this device
command.
• From version 10.00.00, the identification method can
be selected in C02867.
Automatic motor parameter identification
Reserved
Reserved
CAN reset node
• Reinitialise "CAN on board" interface.
• Required when changing the baud rate, node address,
or identifiers.
System bus "CAN on board"
Device search function
• From version 06.00.00
• This device command serves to optically locate a
controller connected online (e.g. for maintenance
work).
Device search function
Check MasterPin
• From version 06.00.00
Unlocking the controller with a MasterPin
Set binding ID
• From version 06.00.00
Device personalisation
Delete binding ID
• From version 06.00.00
Device personalisation
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Data type: UNSIGNED_8
Index: 24573 = 5FFD
d h