Parameterize Controller; General Information On Parameter Setting; Addressing Of The Parameters; Structure Of The Parameter Descriptions - Lenze C520 Commissioning

Commissioning

Parameterize controller

General information on parameter setting

5.12 Parameterize controller
5.12.1 General information on parameter setting
The controller can be parameterized in individual functions. The basic structure of the
parameters is described in the following. The parameter list of the device is only available
after the PLC program has been compiled. This list can be found as a tab under the controller
in the PLC project tree of the »PLC-Designer«.
Certain device commands or settings which might cause a critical state of the
drive behavior can only be carried out when the device is disabled.
5.12.1.1

Addressing of the parameters

Each parameter features a 16-bit index as its address. Under this address, the parameter is
stored in the object directory of the device.
Parameters that belong together functionally are combined in a data set. These
•
parameters are additionally provided with an 8-bit subindex.
The colon is used as a separator between the index and subindex Example: "0x2540:001"
•
There are parameter settings that can be changed, and (diagnostic) parameters that can
•
only be read.
5.12.1.2

Structure of the parameter descriptions

The parameter descriptions in this documentation are structured in table form.
•
The representation distinguishes parameters with a setting range, text, selection list, and
•
bit-coded display.
The default setting of parameters with a write access feature is shown in bold.
•
Example: parameters with a setting range
Address Name / setting range / [default setting]
Index:Subindex Parameter designation
Minimum value ... [default setting] ... maximum value
• Optional information with regard to the parameter.
Example: parameters with a selection list
Address Name / setting range / [default setting]
Index:Subindex Parameter designation
• Optional information with regard to the parameter.
0 Designation of selection 0
1 Designation of selection 1
2 Designation of selection 2
Example with bit coded display
Address Name / setting range / [default setting]
Index:Subindex Parameter designation
• Optional information with regard to the parameter.
Bit 0 Designation of bit 0
Bit 1 Designation of bit 1
Bit 2 Designation of bit 2
... ...
Bit 15 Designation of bit 15
22
Information
Explanations & notes with regard to the parameter.
Information
Explanations & notes with regard to the parameter.
Note: The corresponding selection number (here 0, 1, or 2) must be set.
Other values are not permissible.
Optionally: Explanations & notes with regard to the corresponding
selection.
The default selection is shown in bold.
Information
Explanations & notes with regard to the parameter.
Optionally: Explanations & notes with regard to the corresponding bit.