Lenze L-force HighLine C 8400 Series Reference Manual page 476

8400 HighLine C | Reference manual
Basic drive functions (MCK)
Basic settings
Short overview of machine parameters:
Parameter
C01206/1
C01202/1
C01202/2
C01206/2
C01203/1
C01203/2
C01201/1
C01204
C00011
After the machine parameters have been entered, the drive controller sends back
application-relevant data via the following display parameters:
Parameter
C01211/1
C01205
C01210/5
C00057
C01213/1
Highlighted in grey = display parameter
476
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
Mounting direction: Motor
iM: Nominator of gearbox factor Z2
iM: Denominator of gearbox factor Z1
Mounting direction: Position encoder
iG: Nominator (motor speed)
iG: Denominator (encoder speed)
Axis data: Axis cycle
Activation of the modulo measuring system
Axis data: Feed constant
Appl.: Reference speed
Info
Max. traversing speed 100%_C11
• Is used for orientation when the velocity is being
set in the profile sets.
Axis data: Position resolution
• Is needed for the incremental specification of
positions.
MCK: Positioning accuracy
• Theoretical accuracy during positioning with
account being taken of the machine data and
encoder data.
Maximum torque
MCK: Max. traversing distance
L
Lenze setting
Value Unit
0: Not inverted
1
1
0: Not inverted
1
1
0.0000 units
360.0000 units/rev.
1500 rpm
Lenze setting
Value Unit
- units/s
- incr/unit
- units
- Nm
- units
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011