Setting The Error Response - Lenze L-force HighLine C 8400 Series Reference Manual

9.6.2

Setting the error response

When a monitoring function responds, the response set for this monitoring function
(TroubleQSP, Warning, Fault, etc.) will be triggered.
 For many monitoring functions the response can be individually parameterised via
parameters.

Tip!
The table in chapter
the response can be set .
Warning thresholds
Some of the monitoring functions are activated if a defined warning threshold (e.g.
temperature) has been exceeded.
 The corresponding preset threshold values can be changed via the following
parameters:
Parameter
C00120
C00123
C00572
C00599
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
"Short overview
( 586)
Info
Setting of motor overload (I²xt)
Device utilisat. threshold (Ixt)
Brake resistor overload threshold
Motor phase failure threshold
L
8400 HighLine C | Reference manual
Diagnostics & error management
(A-Z)" contains the error messages for which
Monitoring
575