Selection Of The Technology Application And The Control Mode - Lenze L-force HighLine C 8400 Series Reference Manual

7.1

Selection of the technology application and the control mode

The technology application to be used is selected in C00005.
 You can select the technology application in the »Engineer« on the Application
parameter tab via the Application list field:
Different control modes can be selected for every application in C00007. By selecting the
control mode you set the way by which the technology application should be controlled,
e.g. via terminals or via a fieldbus. The interconnection of the input/output terminals and
ports shown in the FB editor in the I/O level changes accordingly.
 You can select the control mode in the »Engineer« on the Application parameter tab via
the Control mode list field:

Tip!
You can infer the pre-configured assignment of the input/output terminals and
ports for each control mode from the description of the corresponding technology
application:
TA "Actuating drive speed":
TA "Table positioning":
TA "Switch-off positioning":
Detailed information on the individual configuration of the input/output
terminals can be found in the description of the I/O terminals in the subchapter
"User-defined terminal
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
Selection of the technology application and the control mode
Terminal assignment of the control modes
Terminal assignment of the control modes
Terminal assignment of the control modes
assignment".
( 351)
L
Technology applications
( 371)
( 401)
( 428)
359