Lenze L-force HighLine C 8400 Series Reference Manual page 695

Outputs
Identifier
bDone
bFail
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Internal interfaces | System block "LS_WriteParamList"
Value/meaning
Data type
"Writing of the parameter list completed" status signal
• The output is automatically reset to FALSE if writing via bExecute is activated
BOOL
again.
TRUE Writing of the parameter list successfully completed.
FALSE The FALSE status can have the following meanings:
1. There is no active writing of the parameter list.
2. Writing of the parameter list has not been completed yet.
3. An error has occurred (if bFail = TRUE).
"Error" status
BOOL
TRUE An error has occurred (group signal).
• For details see display parameter C01083.
L
8400 HighLine C | Reference manual
Parameter change-over
695