Parameters With Write Access - Lenze L-force HighLine C 8400 Series Reference Manual

14.1.3

Parameters with write access

Only parameters with a check mark ( ) in front of the "write access" attribute can be
changed by the user. The Lenze setting for these parameters is printed in bold.
 The settings can either be selected from a selection list or the values can be entered
directly.
 Values outside the valid setting range are represented in red in the »Engineer«.
14.1.3.1 Parameters with setting range
Description structure
Parameter | Name:
Cxxxxx | _____________
Description
Setting range
(min. value | unit | max. value)
Read access
Parameter setting in the »Engineer«
In the »Engineer«, parameters are set by entering the desired value into the input field:
14.1.3.2 Parameters with selection list
Description structure
Parameter | Name:
Cxxxxx | _____________
Description
Selection list
(Lenze setting printed in bold)
Read access
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Write access CINH PLC STOP
1
2
3
Write access CINH PLC STOP
L
8400 HighLine C | Reference manual
Structure of the parameter descriptions
Lenze setting
No transfer COM MOT Scaling factor: 1
No transfer COM MOT Scaling factor: 1
Parameter reference
Data type: _______
Index: _______
Data type: _______
Index: _______
705