8.4.3
Limit position monitoring
8.4.3.1
Software limit positions
The parameterisable limit positions are used by the software to limit the traversing range.
The positive software limit position is set in
position is set in C01229/2.
Stop!
The software limit positions are only evaluated and monitoring if the drive
knows the home position and the software limit positions for the respective
operating mode have been activated.
• For the "manual jogging" operating mode, travel range monitoring is
switched off by means of parameterisable software limit positions in the
Lenze setting of C01230.
• In the "Homing" and "Positioning" operating modes, the travel range
monitoring is generally switched-on.
Parameter
C01218
- Bit 3
C01219
- Bit 3
C01230
- Bit 3
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
SW limit positions for position follower on/off
SW limit positions for speed follower on/off
SW limit position for manual jogging on/off
L
8400 HighLine C | Reference manual
Basic drive functions (MCK)
C01229/1
and the negative software limit
Basic settings
Lenze setting
On
On
Off
483