Lenze L-force HighLine C 8400 Series Reference Manual page 772

8400 HighLine C | Reference manual
Parameter reference
Parameter list | C00349
C00349
Parameter | Name:
C00349 | CAN setting - DIP switch
DIP switch setting during last mains power-on
Display area
(min. hex value | max. hex value)
0x0000
Value is bit-coded:
Bit 0 Node address 1
Bit 1 Node address 2
Bit 2 Node address 4
Bit 3 Node address 8
Bit 4 Node address 16
Bit 5 Node address 32
Bit 6 Node address 64
Bit 7 Baud rate 1
Bit 8 Baud rate 2
Bit 9 Baud rate 4
Bit 10 Reserved
Bit 11 Reserved
Bit 12 Reserved
Bit 13 Reserved
Bit 14 Reserved
Bit 15 DIP switch at 24V-ON accepted
Read access
C00350
Parameter | Name:
C00350 | CAN node address
Setting of the node address via parameters
• The node address can only be parameterised if the node address "0" is set via the DIP switches.
• A change in the node address will not be effective until a CAN Reset Node is performed.
Setting range
(min. value | unit | max. value)
1
Read access
772
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Write access CINH PLC STOP
Write access CINH PLC STOP
L
0xFFFF
No transfer COM MOT
Lenze setting
127 1
No transfer COM MOT Scaling factor: 1
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Data type: UNSIGNED_16
Index: 24226 = 5EA2
d h
System bus "CAN on board"
Data type: UNSIGNED_8
Index: 24225 = 5EA1
d h
System bus "CAN on board"