Avoiding Thermal Overload Of The Brake Resistor - Lenze L-force HighLine C 8400 Series Reference Manual


How to set the "inverter motor brake" function for a maximum acceleration ramp:
For V/f characteristic open-loop control/closed-loop control (VFCplus):
• Set reduced brake chopper threshold (C00174) to approx. 70 V.
• Set additive speed (C00987) to 1.5 ... 2.5-fold rated slip speed.
• Adapt the deceleration ramp so that the deceleration time is slightly below
(10 ... 30 %) the deceleration time that can be realised with the inverter motor
brake.
For sensorless vector control (SLVC) and servo control (SC):
• Set reduced brake chopper threshold (C00174) to approx. 70 V.
• Set additive speed (C00987) to 2 ... 4-fold rated slip speed.
• Adapt the deceleration ramp so that the deceleration time is slightly below
(10 ... 30 %) the deceleration time that can be realised with the inverter motor
brake.
5.13.3

Avoiding thermal overload of the brake resistor

 Parameterisation of an error response in
error message within the application or within the machine control system.
– See chapter entitled
 External interconnection using the thermal contact on the brake resistor (e.g. supply
interruption via the mains contactor and activation of the mechanical brakes).
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
8400 HighLine C | Reference manual
Braking operation/brake energy management
C00574
"Brake resistor monitoring
L
Motor control (MCTRL)
and evaluation of the parameterised
(I2xt)".
( 293)
287