Lenze L-force HighLine C 8400 Series Reference Manual page 913

C01020
Parameter | Name:
C01020 | L_Odometer_1: Memory length
From version 04.00.00
FB L_Odometer_1: No. of measurements
Selection list
(Lenze setting printed in bold)
Read access
C01021
Parameter | Name:
C01021 | L_Odometer_1: Memory type
From version 04.00.00
FB L_Odometer_1: If "ring buffer" is selected, it is started again after the measurements set in
values are overwritten. Otherwise, the measurement stops.
Selection list
(Lenze setting printed in bold)
Read access
C01022
Parameter | Name:
C01022 | L_Odometer_1: Input selection
From version 04.00.00
FB L_Odometer_1: Selection of position or speed input
Selection list
(Lenze setting printed in bold)
Read access
C01023
Parameter | Name:
C01023 | L_Odometer_1: Edge selection
From version 04.00.00
FB L_Odometer_1: No. of the edge triggering the measurement
Selection list
(Lenze setting printed in bold)
Read access
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
1 1 measurement
2 2 measurements
3 3 measurements
4 4 measurements
5 5 measurements
6 6 measurements
7 7 measurements
Write access CINH PLC STOP
0 No ring buffer
1 Ring buffer
Write access CINH PLC STOP
0 Pos input
1 V input
Write access CINH PLC STOP
0 High edge
1 Low edge
2 High and low edge
Write access CINH PLC STOP
L
8400 HighLine C | Reference manual
No transfer COM MOT Scaling factor: 1
No transfer COM MOT Scaling factor: 1
No transfer COM MOT Scaling factor: 1
No transfer COM MOT Scaling factor: 1
Parameter reference
Parameter list | C01020
Data type: UNSIGNED_8
Index: 23555 = 5C03
d h
Data type: UNSIGNED_8
Index: 23554 = 5C02
d h
C01020 and the old
Data type: UNSIGNED_8
Index: 23553 = 5C01
d h
Data type: UNSIGNED_8
Index: 23552 = 5C00
d h
913