Lenze L-force HighLine C 8400 Series Reference Manual page 51

Short overview of the relevant parameters for device personalisation:
Parameter
C00505/2
Device commands
Before the following device commands are executed, enter the corresponding binding ID in C00505/2.
C00002/29
C00002/30
Status displays
C00003
C00507/1
Highlighted in grey = display parameter
Activating device personalisation
The device personalisation is activated by setting a binding ID.

How to set a binding ID:
1. Enter the desired binding ID in C00505/2.
• The binding ID can have a maximum length of 16 characters.
• The binding ID may contain the following characters:
lower case letters (a - z), upper case letters (A - Z), digits (0 - 9)
2. Execute "Set binding ID" device command
• After successful execution, status ON is displayed in C00505/2.
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Info
Binding ID
• The binding ID can have a maximum length of 16 characters.
• The binding ID may contain the following characters:
lower case letters (a - z), upper case letters (A - Z), digits (0 - 9)
Note:
After the execution of one of the device commands listed below, this
parameter provides the current binding ID status:
OFF No binding ID has been set.
ON Binding ID has been set.
Set binding ID
Activating device personalisation
Delete binding ID
Deactivating the device personalisation/changing the binding ID
Status of the last device command
Password protection - all communication channels
• Bit coded display of the active protective functions:
Bit 0 Only access to user menu
Bit 1 Parameter write protection
Bit 2 Parameter read protection
Bit 3 ... 14 Reserved
Bit 16 Memory module binding on
L
8400 HighLine C | Reference manual
Introduction: Parameterising the controller
Device access protection
C00002/29 = "1: On / start"
Lenze setting
0: Off / ready
0: Off / ready
-
-
51