Lenze L-force HighLine C 8400 Series Reference Manual page 952

8400 HighLine C | Reference manual
Parameter reference
Parameter list | C01245
C01245
Parameter | Name:
C01245 | MCK: Target detection - positions
From version 02.00.00
Position settings for various MCK functions
Setting range
(min. value | unit | max. value)
0.0000
Subcodes
C01245/1
C01245/2
C01245/3
Read access
C01246
Parameter | Name:
C01246 | MCK: Select signal source
From version 06.00.00
Selection of the touch probe signal source for reference search with touch probe detection
• If the reference signal is to follow a real touch probe, the
Selection list
Subcodes
C01246/1
C01246/2
Read access
C01251
Parameter | Name:
C01251 | MCK: Acceleration stop
Acceleration parameter for stop
Setting range
(min. value | unit | max. value)
-214748.3647
Subcodes
C01251/1
Read access
952
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
units 214748.3647
Lenze setting
1.0000 units
1.0000 units
0.0000 units
Write access CINH PLC STOP
0 No TP
3 TP-DigIn3
4 TP-DigIn4
5 TP-DigIn5
6 TP-DigIn6
7 TP-DigIn7
Lenze setting
0: No TP
0: No TP
Write access CINH PLC STOP
units/s2 214748.3647
Lenze setting
720.0000 units/s2
Write access CINH PLC STOP
L
Info
MCK: Window target position
• Window around the target position for comparison
with the actual position to see whether the drive is in
target.
Target position monitoring
MCK: Blocking zone Modulo
• From version 06.00.00
Activation of the Modulo measuring system
MCKI: Hysteresis position change
No transfer COM MOT Scaling factor: 10000
Touch-Probe-Interface
Info
MCK: Ref. TP signal source
MCK: Set.Ref. signal source
No transfer COM MOT Scaling factor: 1
Info
MCK: Stop: Decel.
• Deceleration for setpoint speed ramp-down to
standstill.
No transfer COM MOT Scaling factor: 10000
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Data type: INTEGER_32
Index: 23330 = 5B22
d
Data type: UNSIGNED_8
Index: 23329 = 5B21
d
must be configured accordingly.
Homing
Data type: INTEGER_32
Index: 23324 = 5B1C
d
Stop
h
h
h