Lenze L-force HighLine C 8400 Series Reference Manual page 711

Parameter | Name:
C00002 | Device command
C00002/31
C00002/32
C00002/33
Read access
C00003
Parameter | Name:
C00003 | Status of last device command
Status of the device command carried out last (C00002).
Note:
Before switching off the supply voltage after carrying out a device command, check whether the device command
has been carried out successfully via the status display!
Selection list
(read only)
Read access
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
0: Off / ready
0: Off / ready
0: Off / ready
Write access CINH PLC STOP
0 Successful
1 Command unknown
2 Password protection
3 Time-out
4 System error
5 Command server assigned
6 Controller inhibit required
10 Memory module binding error
11 Password too short
12 Wrong password
13 Password already set
14 Password not assigned
Write access CINH PLC STOP
L
8400 HighLine C | Reference manual
Set password
• From version 06.00.00
Password protection
Check password
• From version 06.00.00
Password protection
Delete password
• From version 06.00.00
Password protection
No transfer COM MOT Scaling factor: 1
Drive control
Info
Device command has been executed successfully.
Device command implausible or unknown to the system.
Unauthorised access for requested device command.
Password protection
Device command could not be processed in the defined
time (timeout).
Device personalisation
Password protection
No transfer COM MOT Scaling factor: 1
Parameter reference
Parameter list | C00003
Data type: UNSIGNED_8
Index: 24573 = 5FFD
d h
Data type: UNSIGNED_8
Index: 24572 = 5FFC
d h
(DCTRL): Device commands
711