Lenze L-force HighLine C 8400 Series Reference Manual page 715

Input/output
RFR
DI1
DI2
DI3
DI4
DI5
DI6
DI7
A1U, A1I
O1U, O1I
O2U, O2I
DO1
DO2
DO3
BD1, BD2
Relay output
Input/output
RFR
DI1
DI2
DI3
DI4
DI5
DI6
A1U
BD1, BD2
C00008
Parameter | Name:
C00008 | Original application|control source
Display of the originally selected technology application and the originally selected control mode.
• This parameter shows the selection that was set with
application level was carried out.
• For diagnostic purposes, this display serves to determine whether there is a standard interconnection in the
controller or a change carried out by the user.
Selection list
(read only)
Firmware ≤ 11.00 - DMS 6.0 EN - 10/2011
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
10: Terminals 0
-
-
Positive limit switch
Negative limit switch
Main speed setpoint (10 V ≡ 100 % reference speed)
Actual speed value (10 V ≡ 100 % reference speed)
Current motor current (10 V ≡ 100 % I
Status "Drive is ready"
Status "Target position (actual value) is in the target window"
Status "Home position is known"
Control of the holding brake
Status "Error is pending"
10: Terminals 0
Controller enable
Fixed setpoint 1/3
Fixed setpoint 2/3
Reset error message
Change of direction of
rotation
-
-
Main speed setpoint (10 V ≡ 100 % reference speed)
Control of the holding brake
0 Free|Free
10 Free|Terminal0
12 Free|Terminal2
14 Free|Terminal11
L
8400 HighLine C | Reference manual
TA "Table positioning"
12: Terminals 2 14: Terminals 11
Controller enable / Reset of error message
- Positive limit switch
- Negative limit switch
-
Positioning profile, array bit (valency 4)
Positioning profile, array bit (valency 2)
Positioning profile, array bit (valency 1)
Start of profile generation
)
max_mot
"Switch-off positioning" TA
12: Terminals 2 14: Terminals 11
Controller enable / Reset of error message
Stop function 1
Stop function 2 Selection: Pre-switch off 1
CW rotation quick stop
Selection: Switch-off position 1
CCW rotation quick stop
Selection: Switch-off position 2
- Stop function 2
- Selection: Pre-switch off 2
C00005 and C00007 before a change in the I/O level or the
Info
Application: Interconnection has been changed.
I/O level: Interconnection has been changed.
Application: Interconnection has been changed.
I/O level: "Terminals 0" control mode
Application: Interconnection has been changed.
I/O level: "Terminal 2" control mode
Application: Interconnection has been changed.
I/O level: "Terminal 11" control mode
Parameter reference
Parameter list | C00008
16: Terminals 16
-
-
- Manual jog
in positive direction
Manual jog
in negative direction
16: Terminals 16
Fixed setpoint 1/3
Fixed setpoint 2/3
CW rotation quick stop
CCW rotation quick stop
-
-
Data type: UNSIGNED_16
Index: 24567 = 5FF7
d h
715