General Notes On Parameters; Changing The Parameterisation With The Keypad - Lenze E84AVSC Operating Instructions Manual

5.2

General notes on parameters

All parameters for controller parameterising or monitoring are saved as so-called "codes".
 The codes are numbered and indicated by the prefix "C" before the code, e.g. "C00002".
 Moreover, each code has a name and specific attributes, as for example access type
(reading, writing), data type, limit values and default setting ("Lenze setting").
 For the sake of clarity, some codes contain "subcodes" for saving parameters. This
Manual uses a slash "/" as a separator between code and subcode, e.g. C00118/3".
 According to their functionality, the parameters are divided into three groups:
– Setting parameters: For specifying setpoints and for setting device / monitoring
functions.
– Configuration parameters: For configuring signal connections and terminal
assignments.
– Diagnostic/display parameters: For displaying device-internal process factors,
current actual values and status messages.
5.2.1

Changing the parameterisation with the keypad

from Firmware V06.00 - DMS 1.1 EN - 11/2011
8400 StateLine C | Operating instructions
The keypad is simply plugged on the
diagnostic interface X6 ("DIAG") at the front
of the standard device.
Plugging and unplugging the keypad is
possible during operation.
L
Before commissioning
General notes on parameters
15