Advertisement
2.9
Usage Note
2.9.1
Notes on Using the Bit Operation Instruction
Instructions BSET, BCLR, BNOT, BST, and BIST read data in byte units, and write data in byte
units after bit operation. Therefore, attention must be paid when these instructions are used for
ports or registers including write-only bits.
Instruction BCLR can be used to clear the flag in the internal I/O register to 0. If it is obvious that
the flag has been set to 1 by the interrupt processing routine, it is unnecessary to read the flag
beforehand.
Rev. 1.00 Mar. 12, 2008 Page 59 of 1178
REJ09B0403-0100
Section 2 CPU
Advertisement
