Advertisement
12.6
Usage Notes
12.6.1
Notes on Register Access
The watchdog timer's registers, TCNT and TCSR differ from other registers in being more
difficult to write to. The procedures for writing to and reading from these registers are given
below.
Writing to TCNT and TCSR (Example of WDT_0):
These registers must be written to by a word transfer instruction. They cannot be written to by a
byte transfer instruction.
TCNT and TCSR both have the same write address. Therefore, satisfy the relative condition
shown in figure 12.6 to write to TCNT or TCSR. To write to TCNT, the higher bytes must contain
the value H'5A and the lower bytes must contain the write data. To write to TCSR, the higher
bytes must contain the value H'A5 and the lower bytes must contain the write data.
<TCNT write>
Address : H'FFA8
<TCSR write>
Address : H'FFA8
Reading from TCNT and TCSR (Example of WDT_0):
These registers are read in the same way as other registers. The read address is H'FFA8 for TCSR
and H'FFA9 for TCNT.
15
15
Figure 12.6 Writing to TCNT and TCSR (WDT_0)
Section 12 Watchdog Timer (WDT)
8 7
H'5A
8 7
H'A5
Rev. 1.00 Mar. 12, 2008 Page 425 of 1178
0
Write data
0
Write data
REJ09B0403-0100
Advertisement
