Clock - Renesas H8S Family Hardware Manual

Section 13 Serial Communication Interface (SCI)

Clock

Either an internal clock generated by the on-chip baud rate generator or an external clock input at

the SCK pin can be selected as the SCI's transfer clock, according to the setting of the C/A bit in

SMR and the CKE1 and CKE0 bits in SCR. When an external clock is input at the SCK pin, the

clock frequency should be 16 times the bit rate used.

When the SCI is operated on an internal clock, the clock can be output from the SCK pin. The

frequency of the clock output in this case is equal to the bit rate, and the phase is such that the

rising edge of the clock is in the middle of the transmit data, as shown in figure 13.4.

Figure 13.4 Relation between Output Clock and Transmit Data Phase

Rev. 1.00 Mar. 12, 2008 Page 452 of 1178

REJ09B0403-0100

(Asynchronous Mode)