Frame Relay Subinterface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
F R
RAME ELAY
To create a virtual Frame Relay subinterface and activate the Frame Relay Subinterface Configuration
mode, enter the interface frame-relay command (and specify a subinterface) at the Global Configuration
mode prompt. For example:
>enable
#configure terminalF
(config)#interface frame-relay 1.16
(config-fr 1.16)#
By default, Frame Relay subinterfaces are created as point-to-point links. This default setting cannot be
altered. The following command creates the exact same interface as that mentioned above:
>enable
#configure terminal
(config)#interface frame-relay 1.16 point-to-point
(config-fr 1.16)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias "<text>" on page 66
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 2195
bridge-group <number> on page 2196
bridge-group <number> vlan-transparent on page 2197
crypto map <name> on page 2198
dial-backup commands begin on page 2200
dynamic-dns on page 2217
frame-relay commands begin on page 2219
ip commands begin on page 2223
ipv6 commands begin on page 2266
lldp receive on page 2294
lldp send on page 2295
60000CRG0-35E
S
UBINTERFACE
Copyright © 2012 ADTRAN, Inc.

Frame Relay Subinterface Command Set

C S
OMMAND ET
2193