Command Reference Guide
frame-relay interface-dlci <value>
Use the frame-relay interface-dlci command to configure the data link connection identifier (DLCI) for
the Frame Relay subinterface. This setting should match the DLCI supplied by your Frame Relay service
provider. Use the no form of this command to remove the configured DLCI.
Syntax Description
<value>
Default Values
By default, the DLCI is populated with the subinterface identifier. For example, if configuring the virtual
Frame Relay subinterface labeled fr 1.20, the default DLCI is 20.
Command History
Release 1.1
Usage Examples
The following example configures a DLCI of 72 for this Frame Relay endpoint:
(config)#interface frame-relay 1.16
(config-fr 1.16)#frame-relay interface-dlci 72
60000CRG0-35E
Specifies numeric value of the DLCI supplied by your provider.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2222