Table of Contents
Advertisement
Command Reference Guide
frame-relay fragment <value>
Use the frame-relay fragment command to set the FRF.12 fragmentation threshold. Use the no form of
this command to erase the configured threshold.
Syntax Description
<value>
Default Values
No default values are necessary for this command.
Command History
Release 6.1
Functional Notes
For Frame Relay fragmentation to take effect, rate-limiting must be enabled by setting the committed burst
rate and excessive burst rate. Refer to
on page 2220
for more information.
Usage Examples
The following example enables FRF.12 fragmentation on a sublink:
(config)#interface frame-relay 1.16
(config-fr 1.16)#frame-relay bc 64000
(config-fr 1.16)#frame-relay be 16
(config-fr 1.16)#frame-relay fragment 100
The following example disables FRF.12 fragmentation on a sublink:
(config)#interface frame-relay 1.16
(config-fr 1.16)#no frame-relay fragment
60000CRG0-35E
Specifies the fragmentation threshold. Valid fragmentation thresholds are
greater than or equal to 64 and less than or equal to 1600.
Command was introduced.
frame-relay bc <value> on page 2219
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
and
frame-relay be <value>
2221
Advertisement
Table of Contents
