Table of Contents
Advertisement
Command Reference Guide
frame-relay be <value>
Use the frame-relay be command to set the b
value is in bits. Use the no form of this command to return to the default value.
Syntax Description
<value>
Default Values
By default, the excessive burst value is set to 0 (no limit).
Command History
Release 4.1
Functional Notes
The time interval is always one second, so this can also be considered bits per second. Shaping is
performed on a sliding one-second window to make maximum use of configured bandwidth. Note that
when both b c and b e are nonzero, shaping is performed on the virtual circuit. The circuit is limited to the
sum of b c and b e , and it is recommended that the sum always be greater than 8000.
Usage Examples
The following example configures the Frame Relay sublink with an excessive burst value of 64,000 bits:
(config)#interface frame-relay 1.16
(config-fr 1.16)#frame-relay be 64000
60000CRG0-35E
(excessive burst) value for a Frame Relay sublink. The
e
Specifies the excessive burst value (in bits) for the sublink.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2220
Advertisement
Table of Contents
