Static-Rp - H3C S3600 Series Command Manual

Command Manual – Multicast
H3C S3600 Series Ethernet Switches-Release 1510
[H3C-acl-basic-2000] rule permit source 10.10.1.2 0
[H3C-acl-basic-2000] rule deny source 10.10.1.1 0

6.1.22 static-rp

Syntax
static-rp rp-address [ acl-number ]
undo static-rp
View
PIM view
Parameter
rp-address: Static RP address. It must be a legal unicast IP address.
acl-number: Basic ACL, used to control the range of multicast group served by static RP.
Its value ranges from 2000 to 2999. If no ACL is specified upon configuration, static RP
will serve all multicast groups; if an ACL is specified, static RP will only serve the
multicast group passing the ACL.
Description
Use the static-rp command to configure static RP.
Use the undo static-rp command to remove the configuration.
Static RP functions as the backup of dynamic RP to improve network robustness. If the
RP elected by BSR mechanism is valid, static RP will not work. All routers in the PIM
domain must be configured with this command and be specified with the same RP
address.
The new configuration overwrites the old one if you execute the command for a second
time.
Related command: display pim rp-info.
Example
# Configure 10.110.0.6 as a static RP.
<H3C>system-view
System View: return to User View with Ctrl+Z.
[H3C] multicast routing-enable
[H3C] pim
[H3C-pim] static-rp 10.110.0.6
Chapter 6 PIM Configuration Commands
6-21