Table of Contents
Advertisement
Associating Outlets with Target Devices
The Port page opens when you click on a port on the Port Configuration page.
If an outlet is connected to the same server that the port is connected to, a
power association can be made with the target device.
A server can have up to four power plugs and you can associate a different rack
PDU (power strip) with each. From this page, you can define those associations
so that you can power on, power off, and power cycle the server from the Port
Access page.
To use this feature, you will need:
•
Raritan remote rack PDU(s)
•
Power CIMs (D2CIM-PWR)
Make a Power Association
To make power associations (associate rack PDU outlets to KVM target
servers):
Note: When a rack PDU is associated to a target server (port), the outlet name
is replaced by the target server name (even if you assigned another name to the
outlet).
1.
On the Port Configuration page, select the target server you are
associating the PDU with.
2.
Choose the rack PDU from the Power Strip Name drop-down list.
3.
For that rack PDU, choose the outlet from the Outlet Name drop-down list.
4.
Repeat steps 1 and 2 for all desired power associations.
5.
Click OK. A confirmation message is displayed.
Turning Outlets On/Off and Cycling Power
To turn an outlet on:
1.
Click the Power menu to access the Powerstrip page.
2.
From the Powerstrip drop-down, select the PX rack PDU (power strip) you
want to turn on.
3.
Click Refresh to view the power controls.
4.
Click On next to the outlet you want to power on.
5.
Click OK to close the Power On confirmation dialog. The outlet will be
turned on and its state will be displayed as 'on'.
To turn an outlet off:
1.
Click Off next to the outlet you want to power off.
2.
Click OK on the Power Off dialog.
Appendix K: Integration
871
Advertisement
Table of Contents
Troubleshooting
