Load Shedding Configuration Commands - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface
config:# sensor ocp 2 current upperCritical disable upperWarning 15

Load Shedding Configuration Commands

696
Results:
•
The Upper Critical threshold of the 2nd overcurrent protector's RMS
current is disabled.
•
The Upper Warning threshold of the 2nd overcurrent protector's RMS
current is set to 15A and enabled at the same time.
Example 3 - Combination of SSID and PSK Parameters
This multi-command syntax configures both SSID and PSK parameters
simultaneously for the wireless feature.
config:# network wireless SSID myssid PSK encryp_key
Results:
•
The SSID value is set to myssid.
•
The PSK value is set to encryp_key.
This section applies to outlet-switching capable models only.
A load shedding configuration command begins with loadshedding.
Unlike other CLI configuration commands, the load shedding configuration
command is performed in the administrator mode rather than the
configuration mode. See Different CLI Modes and Prompts (on page 527).