LEGRAND Raritan PX3TS User Manual page 643

config:# security roleBasedAccessControl ipv4 rule add <start_ip> <end_ip> <role>
<policy>
config:# security roleBasedAccessControl ipv4 rule add <start_ip> <end_ip> <role>
<policy> <insert> <rule_number>
config:# security roleBasedAccessControl ipv6 rule add <start_ip> <end_ip> <role>
<policy>
Managing Role-Based Access Control Rules
You can add, delete or modify role-based access control rules.
•
An IPv4 role-based access control command for managing rules begins
with security roleBasedAccessControl ipv4 rule.
•
An IPv6 role-based access control command for managing rules begins
with security roleBasedAccessControl ipv6 rule.
Adding a Role-Based Access Control Rule
Depending on where you want to add a new rule in the list, the command
syntax for adding a rule varies.
•
IPv4 commands
Add a new rule to the bottom of the IPv4 rules list:
Add a new IPv4 rule by inserting it above or below a specific rule:
•
IPv6 commands
Add a new rule to the bottom of the IPv6 rules list:
Add a new IPv6 rule by inserting it above or below a specific rule:
Chapter 9: Using the Command Line Interface
623