LEGRAND Raritan PX3TS User Manual page 155

6. Press the FUNC button to display the X, Y and Z coordinates of the sensor
respectively.
▪
X coordinate is shown as "x:NN," where NN are the first two numeric
digits entered for the X coordinate in the web interface.
▪
Y coordinate is shown as "y:NN," where NN are the first two numeric
digits entered for the Y coordinate in the web interface.
▪
Z coordinate is shown as "z:NN," where NN are the first two numeric
digits entered for the Z coordinate in the web interface.
If one or both of the first two digits for a specific coordinate are
alphabetical characters, these alphabetical characters are replaced with
dashes (-).
7. Press the FUNC button to display the serial number of the sensor, which is
shown as "s:XX," where XX are two digits of the serial number. The LCD will
cycle through the serial number from the first two digits to the final two.
For example, if the serial number is AE17A00022, the LCD display shows
the following information one after another:
s:AE --> s:17 --> s:A0 --> s:00 --> s:22
Note: Some alphabets cannot be properly displayed due to the LCD display
restriction. For example, Q looks like 9, Z looks like 2, and M looks like
Check the sensor's label or the web interface when you have doubts.
Outlet Switching
This section applies to outlet-switching capable models only.
You can turn on or off any outlet using the LCD display in the outlet switching
mode. To do this, you must first enable the front panel outlet control function.
See Front Panel Settings
To turn on or off an outlet:
1. Press the MODE button until the LCD display enters the outlet switching
mode, which is indicated by the power state of OUTLET 1.
▪
When outlet 1 has been powered on, the word 'on' is displayed as
shown below.
▪
When outlet 1 has been powered off, the word "oFF" is displayed
instead.
2. Press the Up or Down button to select the desired outlet. The selected
outlet's number is displayed at the top of the LCD display.
(on page 454).
Chapter 6: Using the PX3TS
.
135