Table of Contents
Advertisement
Chapter 7: Using the Web Interface
352
To configure IPv6 access control rules:
1.
On the same page, select the 'Enable IPv6 access control' checkbox to
enable IPv6 access control rules.
2.
Follow the same procedure as the above IPv4 rule setup to create IPv6
rules.
3.
Make sure you click the Save button in the IPv6 section, or the changes
made to IPv6 rules are not saved.
Editing or Deleting IP Access Control Rules
When an existing IP access control rule requires updates of IP address range
and/or policy, modify them accordingly. Or you can delete any unnecessary
rules.
To modify or delete a rule:
1.
Choose Device Settings > Security > IP Access Control.
2.
Go to the IPv4 or IPv6 section.
3.
Select the desired rule in the list.
▪
Ensure the IPv4 or IPv6 checkbox has been selected, or you may not
edit or delete any rule.
4.
Perform the desired action.
▪
Make changes to the selected rule, and then click Save. For
information on each field, see
page 349).
▪
Click
to remove it.
▪
To resort its order, click
5.
Click Save.
▪
IPv4 rules: Make sure you click the Save button in the IPv4 section, or
the changes made to IPv4 rules are not saved.
▪
IPv6 rules: Make sure you click the Save button in the IPv6 section, or
the changes made to IPv6 rules are not saved.
Creating IP Access Control Rules
or
.
(on
Advertisement
Table of Contents
Troubleshooting
