LEGRAND Raritan PX3TS User Manual page 587

config:# ts powerQualityParameters lowerCriticalVoltage <threshold_volts>
config:# ts powerQualityParameters lowerWarningVoltage <threshold_volts>
config:# ts powerQualityParameters upperCriticalVoltage <threshold_volts>
•
<option3> is an integer number up to 180 in seconds.
•
<option4> is one of the options: enable or disable.
Option Description
enable Automatic retransfer is performed only when inlets
are in phase.
disable Automatic retransfer is performed regardless of the
phase angle difference.
•
<name> is a string comprising up to 64 ASCII printable characters. The
<name> variable must be enclosed in quotes when it contains spaces.
Example
The following command disables the front panel Manual Transfer button and
enables the Auto Retransfer feature.
config:# ts manualTransferButton disable autoRetransfer enable
Configuring Power Quality Parameters
All CLI commands used to configure power quality parameters begin with ts
powerQualityParameters. Enter the configuration mode before performing any
of these commands. See Entering Configuration Mode
You can configure all of the following power quality parameters at a time by
combining all commands. See
Set the Lower Critical voltage threshold:
Set the Lower Warning voltage threshold:
Set the Upper Critical voltage threshold:
Set the Upper Warning voltage threshold:
Chapter 9: Using the Command Line Interface
(on page 563).
Multi-Command Syntax (on page 695).
567