LEGRAND Raritan PX3TS User Manual page 426

Chapter 7: Using the Web Interface
406
Send Sensor Report
You may set the PX3TS so that it automatically reports the latest readings or
states of one or multiple sensors by sending a message or email or simply
recording the report in a log. These sensors can be either internal or
environmental sensors listed below.
•
Inlet sensors, including RMS current, RMS voltage, active power, apparent
power, power factor and active energy.
•
Outlet state sensors, which are available on outlet-switching capable PDUs
only.
•
Overcurrent protector sensors, including RMS current and tripping state.
•
Peripheral device sensors, which can be any Raritan environmental sensor
packages connected to the PX3TS, such as temperature or humidity
sensors.
An example of this action is available in the section titled
Example (on page 419).
Operation:
1. Choose Device Settings > Event Rules >
2. Select 'Send sensor report' from the Action list.
3. In the 'Destination actions' section, select the method(s) to report sensor
readings or states. The number of available methods varies, depending on
how many messaging actions have been created.
The messaging action types include:
▪
Log event message
▪
Syslog message
▪
Send email
▪
Send SMS message
4. If no messaging actions are available, create them now. See
Actions (on page 394).
a. To select any methods, select them one by one in the Available field.
To add all available methods, simply click Select All.
b. To delete any methods, click a method's
To remove all methods, simply click Deselect All.
5. In the 'Available sensors' field, select the desired target's sensor.
a. Click the first to select a target component from the list.
Send Sensor Report
.
Available
in the Selected field.