Table of Contents
Advertisement
b. Click Edit Thresholds.
c.
Enable and set the desired thresholds and deassertion hysteresis.
Note that assertion timeout is NOT available on LHX/SHX.
d. Click Save.
3.
After thresholds are enabled, sensors may be highlighted in yellow or red if
they enter the warning or critical range. See
Sensors
(on page 264).
Tip: You can also create event rules to notify you of the warning or critical levels.
See
Event Rules and Actions
To view sensor alerts and LHX event log:
Remote alert acknowledgment is supported by the LHX-20 and LHX-40. The
SHX-30 does not support this feature.
1.
Locate the Alert States section.
Chapter 7: Using the Web Interface
Yellow- or Red-Highlighted
(on page 375).
293
Advertisement
Table of Contents
Troubleshooting
