LEGRAND Raritan PX3TS User Manual page 598

Chapter 9: Using the Command Line Interface
578
Interface Description
eth1 Determine the IPv4 configuration mode of the ETH1
interface (wired networking).
eth2 Determine the IPv4 configuration mode of the ETH2
interface (wired networking).
Determine the IPv4 configuration mode of the
wireless
WIRELESS interface (that is, wireless networking).
bridge Determine the IPv4 configuration mode of the BRIDGE
interface (that is, bridging mode).
•
<mode> is one of the modes: dhcp or static.
Mode Description
dhcp The IPv4 configuration mode is set to DHCP.
static The IPv4 configuration mode is set to static IP address.
Setting the IPv4 Preferred Host Name
After selecting DHCP as the IPv4 configuration mode, you can specify the
preferred host name, which is optional. The following is the command:
config:# network ipv4 interface <ETH> preferredHostName <name>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Determine the IPv4 preferred host name of the ETH1
interface (that is, wired networking).
eth2 Determine the IPv4 preferred host name of the ETH2
interface (that is, wired networking).
wireless Determine the IPv4 preferred host name of the
WIRELESS interface (that is, wireless networking).