Quitting Configuration Mode; Px3Ts Control And Configuration; Controlling The Transfer Switch - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface

Quitting Configuration Mode

PX3TS Control and Configuration

564
Both of "apply" and "cancel" commands let you quit the configuration mode.
The difference is that "apply" saves all changes you made in the configuration
mode while "cancel" aborts all changes.
To quit the configuration mode, use either command:
config:# apply
-- OR --
config:# cancel
The # or > prompt appears after pressing Enter, indicating that you have
entered the administrator or user mode. See
(on page 527).
To configure the PX3TS device or network settings through the CLI, it is highly
recommended to log in as the administrator so that you have full permissions.
To configure any settings, enter the configuration mode. Configuration
commands are case sensitive so ensure you capitalize them correctly.

Controlling the Transfer Switch

A transfer switch command begins with ts. You can use these commands to
control the power transfer behavior or manage power transfer settings.
Performing Manual Transfer
Performing manual transfer remotely requires either of these permissions:
"Switch Transfer Switch" or "Administrator Privileges."
To verify the current active inlet and preferred inlet configuration via CLI, see
Transfer Switch Information
To perform manual transfer via CLI:
1. Ensure that the current mode is the administrator or user mode. See
Different CLI Modes and Prompts
2. Type either of the following commands and press Enter.
ts transfer <inlet>
#
OR
ts transfer <inlet> /y
#
<inlet> is one of the inlet numbers: 1 or 2.
Different CLI Modes and Prompts
(on page 530).
(on page 527).