LEGRAND Raritan PX3TS User Manual page 872

Appendix J: Additional PX3TS Information
852
▪
To change it, follow onscreen instructions to type your new password.
▪
To ignore it, simply press Enter.
6. The # prompt appears.
Type config and press Enter.
7.
8. To configure network settings, type appropriate commands and press
Enter. Refer to the following commands list. CLI commands are case
sensitive.
After finishing the network settings, type apply to save changes. To abort,
9.
type cancel.
Commands for wired networking:
The <ipvX> variable in the following commands is either ipv4 or ipv6,
depending on the type of IP protocol you are configuring.
For PX2 and "old" PX3 that have only one Ethernet port, replace the variable
<ETH> with the word "ethernet". For PX3 that has two Ethernet ports, replace
the variable <ETH> with either 'ETH1' or 'ETH2', depending on which Ethernet
port you are configuring.
•
General IP settings:
To set or Use this command
enable
network <ipvX> interface <ETH>
IPv4 or IPv6
enabled <option>
protocol
<option> = true, or false
network ipv4 interface <ETH>
IPv4
configMethod <mode>
configuration
method
<mode> = dhcp (default) or static
network ipv6 interface <ETH>
IPv6
configMethod <mode>
configuration
method
<mode> = automatic (default) or static
network <ipvX> interface <ETH>
Preferred host
preferredHostName <name>
name (optional)
<name> = preferred host name
network dns resolverPreference
IP address
<resolver>
returned by the
DNS server
<resolver> = preferV4 or preferV6