Transfer Switch - LEGRAND Raritan PX3TS User Manual

Transfer Switch

•
A bar showing OCP current levels
•
OCP status -- open or closed
•
Associated line pair
The RMS current bars automatically change colors to indicate the current
status if OCP thresholds have been enabled. To configure thresholds, see
(on page 249).
Status
normal
above upper warning
above upper critical
Note: The "below lower warning" and "below lower critical" states also show
yellow and red colors respectively. However, it is not meaningful to enable the
two thresholds for current levels.
On the Transfer Switch page, you can:
•
View the transfer switch status, and the history of last several transfers,
such as the transfer log.
•
Change power transfer settings.
•
Determine the power quality thresholds of voltage and frequency.
•
Perform manual power transfer or retransfer
Note: Whenever the PX3TS prevents a manual transfer from being performed, it
is disabled across all interfaces, including the front panel button, web interface
and CLI command.
To open the Transfer Switch page, click 'Transfer Switch' in the
176).
Transfer switch-related information shown:
•
Transfer switch status
•
Status of Inlet sensors related to the transfer switch
•
Indicate which one is the 'active' inlet by showing
inlet's section
If is not shown on any inlet, neither inlet is powering the
outlets, which is the "off" state.
Chapter 7: Using the Web Interface
Bar colors
OCPs
Menu (on page
on either
193