LEGRAND Raritan PX3TS User Manual page 331

After enabling either or both Internet protocols:
After enabling IPv4 and/or IPv6, all but not limited to the following protocols
will be compliant with the selected Internet protocol(s):
•
LDAP
•
NTP
•
SMTP
•
SSH
•
Telnet
•
FTP
•
SSL/TLS
•
SNMP
•
SysLog
Note: PX3TS disables TLS 1.0 and 1.1 by default. It enables only TLS 1.2 and 1.3.
Wired Network Settings
On the Network page, click the ETH1/ETH2 section to configure IPv4/IPv6
settings.
If the device's cascading mode is set to 'Bridging', the BRIDGE section appears.
Then you must click the BRIDGE section for IPv4/IPv6 settings. See
Cascading Mode (on page 328).
Enable Interface:
Make sure the Ethernet interface is enabled, or all networking through this
interface fails. This setting is available in the ETH1/ETH2 section, but not
available in the BRIDGE section.
IPv4 settings:
Field/setting
Enable IPv4
IP auto configuration Select the method to configure IPv4 settings.
Preferred hostname
Chapter 7: Using the Web Interface
Description
Enable or disable the IPv4 protocol.
▪ DHCP: Auto-configure IPv4 settings via DHCP
servers.
▪ Static: Manually configure the IPv4 settings.
Enter the hostname you prefer for IPv4 connectivity
Setting the
311