LEGRAND Raritan PX3TS User Manual page 603

•
Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv6 Address
After selecting the static IP configuration mode, you can use this command to
assign a permanent IP address to the PX3TS.
config:# network ipv6 interface <ETH> address <ip
address>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Determine the IPv6 address of the ETH1 interface
(wired networking).
eth2 Determine the IPv6 address of the ETH2 interface
(wired networking).
wireless Determine the IPv6 address of the WIRELESS interface
(that is, wireless networking).
Determine the IPv6 address of the BRIDGE interface
bridge
(that is, the bridging mode).
•
<ip address> is the IP address being assigned to your PX3TS. This value
uses the IPv6 address format. Note that you must add /xx, which indicates
a prefix length of bits such as /64, to the end of this IPv6 address.
Chapter 9: Using the Command Line Interface
583