LEGRAND Raritan PX3TS User Manual page 615

If Port Forwarding mode is enabled, you must configure two more
settings to finish the configuration:
On ALL cascaded devices, you must configure the 'role' setting one by one.
config:# network portForwarding role <option2>
On the master device, you must configure the 'downstream interface' setting.
config:# network portForwarding
masterDownstreamInterface <option3>
Variables:
•
<option2> is one of the following cascading roles:
Role
master
slave
•
<option3> is one of the following options:
Option
ETH1/ETH2
Usb
Setting Network Service Parameters
A network service command begins with network services.
Chapter 9: Using the Command Line Interface
Description
The device is a master device.
The device is a slave device.
Description
ETH1/ETH2 port is the port where the 1st slave
device is connected.
USB port is the port where the 1st slave device
is connected.
595