LEGRAND Raritan PX3TS User Manual page 648

Chapter 9: Using the Command Line Interface
config:# security ipAccessControl ipv4 enabled true defaultPolicyIn accept
defaultPolicyOut accept
config:# security ipAccessControl ipv4 rule add in 192.168.84.123/24 accept
insertAbove 5
628
Examples
This section illustrates several security configuration examples.
Example 1 - IPv4 Firewall Control Configuration
The following command sets up two parameters of the IPv4 access control
feature.
Results:
•
The IPv4 access control feature is enabled.
•
The default policy for inbound traffic is set to "accept."
•
The default policy for outbound traffic is set to "accept."
Example 2 - Adding an IPv4 Firewall Rule
The following command adds a new IPv4 access control rule and specifies its
location in the list.
Results:
•
A new IPv4 firewall control rule is added to accept all packets sent from
the IPv4 address 192.168.84.123.
•
The newly-added rule is inserted above the 5th rule. That is, the new rule
becomes the 5th rule, and the original 5th rule becomes the 6th rule.
Example 3 - User Blocking
The following command sets up two user blocking parameters.