LEGRAND Raritan PX3TS User Manual page 436

Chapter 7: Using the Web Interface
Transport Next steps
protocols
A TLS certificate is required. Do the following:
a.
b. In the 'CA certificate' field, click
TCP+TLS
c.
416
Type an appropriate port number in the 'TCP port' field. Default is 6514.
certificate, you may:
▪
Click Show to view its contents.
▪
Click Remove to delete it if it is inappropriate.
Determine whether to select the 'Allow expired and not yet valid certificates' checkbox.
▪
To always send the event message to the specified syslog server as long as a TLS certificate
is available, select this checkbox.
▪
To prevent the event message from being sent to the specified syslog server when any TLS
certificate in the selected certificate chain is outdated or not valid yet, deselect this
checkbox.
Note: If the required certificate file is a chain of certificates, and you are not
sure about the requirements of a certificate chain, see
page 859).
Scheduling an Action
An action can be regularly performed at a preset time interval instead of being
triggered by a specific event. For example, you can make the PX3TS report the
reading or state of a specific sensor regularly by scheduling the "Send sensor
report" action.
When scheduling an action, make sure you have a minimum of 1-minute buffer
between this action's creation and first execution time. Otherwise, the
scheduled action will NOT be performed at the specified time when the buffer
time is too short. For example, if you want an action to be performed at 11:00
am, you should finish scheduling it at 10:59 am or earlier.
If the needed action is not available yet, create it first. See
(on page 394).
Operation:
1. Choose Device Settings > Event Rules >
2. To select any action(s), select them one by one from the 'Available actions'
list.
▪
To select all available actions, click Select All.
to select a TLS certificate. After importing the
TLS Certificate Chain
Available Actions
.
(on