LEGRAND Raritan PX3TS User Manual page 714

Chapter 9: Using the Command Line Interface
694
Setting the Baud Rates
The following commands set the baud rate (bps) of the serial port labeled
CONSOLE / MODEM on the PX3TS device. Change the baud rate before
connecting it to the desired device, such as a computer, a Raritan's P2CIM-SER,
or a modem, through the serial port, or there are communications errors. If
you change the baud rate dynamically after the connection has been made,
you must reset the PX3TS or power cycle the connected device for proper
communications.
Determine the CONSOLE baud rate:
config:# serial consoleBaudRate <baud_rate>
Note: The serial port bit-rate change is required when the PX3TS works in
conjunction with Raritan's Dominion LX KVM switch. Dominion LX only supports
19200 bps for communications over the serial interface.
Determine the MODEM baud rate:
config:# serial modemBaudRate <baud_rate>
Variables:
•
<baud_rate> is one of the baud rate options: 1200, 2400, 4800, 9600,
19200, 38400, 57600, 115200.
Forcing the Device Detection Mode
This command forces the serial port on the PX3TS to enter a specific device
detection mode.
config:# serial deviceDetectionType <mode>
Variables:
•
<mode> is one of the detection modes: automatic, forceConsole,
forceAnalogModem, or forceGsmModem.
Option
automatic
forceConsole
Description
The PX3TS automatically detects the type of the
device connected to the serial port.
Select this option unless your PX3TS cannot
correctly detect the device type.
The PX3TS attempts to recognize that the
connected device is set for the console mode.