Showing Information; Transfer Switch Information - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface

Showing Information

530
You can use the show commands to view current settings or the status of the
PX3TS device or part of it, such as the IP address, networking mode, firmware
version, states or readings of internal or external sensors, user profiles, and so
on.
Some "show" commands have two formats: one with the parameter "details"
and the other without. The difference is that the command without the
parameter "details" displays a shortened version of information while the other
displays in-depth information.
After typing a "show" command, press Enter to execute it.
Note: Depending on your login name, the # prompt may be replaced by the >
prompt. See Different CLI Modes and Prompts

Transfer Switch Information

This command shows the transfer switch-related information of the PX3TS
device.
# show ts
To show detailed information, add the parameter "details" to the end of the
command.
# show ts details
Displayed information includes:
•
Transfer switch label and custom name in parentheses
•
Operational state
•
Preferred inlet
•
Active inlet
•
Inlet phase sync status
•
Inlet phase angle and state
•
Overload status
•
Transfer switch status
•
The following information for each inlet:
- Fuse status
- Power quality
- RMS voltage and state*
- Line frequency and state*
- 12V power supply state*
(on page 527).