LEGRAND Raritan PX3TS User Manual page 599

Interface Description
bridge Determine the IPv4 preferred host name of the
BRIDGE interface (that is, bridging mode).
•
<name> is a host name which:
▪
Consists of alphanumeric characters and/or hyphens
▪
Cannot begin or end with a hyphen
▪
Cannot contain more than 63 characters
▪
Cannot contain punctuation marks, spaces, and other symbols
Setting the IPv4 Address
After selecting the static IP configuration mode, you can use this command to
assign a permanent IP address to the PX3TS.
config:# network ipv4 interface <ETH> address <ip address>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface Description
eth1 Determine the IPv4 address of the ETH1 interface
(that is, wired networking).
eth2 Determine the IPv4 address of the ETH2 interface
(that is, wired networking).
wireless Determine the IPv4 address of the WIRELESS interface
(that is, wireless networking).
bridge Determine the IPv4 address of the BRIDGE interface
(that is, the bridging mode).
•
<ip address> is the IP address being assigned to your PX3TS. Its format is
"IP address/prefix". For example, 192.168.84.99/24.
Chapter 9: Using the Command Line Interface
579