Table of Contents
Advertisement
Asset Strip Information
If there is any asset strip connected to the PX3TS, you can enter the Asset Strip
mode to show the asset tag state of each rack unit on the asset strip. A rack
unit refers to a tag port on the asset strips.
When there are no asset strips connected, this mode is not available.
Below illustrates the asset strip information.
Section
Example information
"1" refers to the asset strip connected to the first FEATURE
port.
This symbol
rack units now by pressing the Up or Down button.
"30" indicates that the selected target is the 30th rack unit.
"MASTER" indicates the PX3TS is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in Port
Forwarding mode.
"ASSET" means that the LCD display enters the Asset Strip
mode.
To display the asset management information:
1.
Press the MODE button until the PX3TS enters the Asset Strip mode, as
indicated by "ASSET" to the right of the LCD.
2.
By default the PX3TS selects the asset strip connected to the first FEATURE
port so it shows "1" at the top. Because the PX3TS has only one FEATURE
port, "1" is the only option.
3.
Press the FUNC button. When a blinking double-arrow symbol
to the left of the LCD display, press the Up or Down button to select the
desired rack unit on the asset strip. The rack unit number appears in the
middle of the LCD display.
indicates that you can switch between diverse
Chapter 6: Using the PX3TS
appears
137
Advertisement
Table of Contents
Troubleshooting
