Chapter 7: Using the Web Interface
230
Tip: The above two icons are switched if you manually perform any power
operations on non-critical outlets during the load shedding mode. See
and Lock Icons for Outlets
▪
The message "Load shedding active" appears next to the 'Outlets' title.
▪
The Non Critical column, if not shown prior to the load shedding mode,
automatically displays on the Outlets page.
Tip: To make the Non-Critical column appear when the load shedding mode is
not activated yet. See
Outlets
Overview Page
(on page 224).
To exit from the load shedding mode:
1.
On the Outlets page, click
2.
Click Deactivate on the confirmation message.
Now you can turn on/off any outlets.
TIP -- automatic load shedding via contact closure sensors:
If you have connected a Raritan contact closure sensor to PX3TS, you can set up
an event rule in a manner that this sensor's status change automatically
activates or deactivates the load shedding mode. For an example, see
Environmental-Sensor-Level Event Rule
(on page 231).
(on page 220) or
Available Data of the Outlets
> Deactivate Load Shedding.
(on page 433).
Off
Sample