Connecting A Mobile Device To Px3Ts - LEGRAND Raritan PX3TS User Manual

▪
For PX3TS, see IPv4 Address
▪
For PX3TS-iX7, see
3. Launch a web browser to configure the PX3TS. See
Configuration via a connected mobile device:
1. Download the PDView app to your mobile device. See
Mobile Device to PX3TS
2. Connect the mobile device to PX3TS via USB.
3. Launch PDView to configure the PX3TS.
Configuration via a connected computer:
1. Connect the PX3TS to a computer. See
Computer (on page 23).
2. Use the connected computer to configure the PX3TS via the command line
or web interface.
▪
Command line interface: See
page 851).
▪
Web interface: Launch the web browser on the computer, and type
the link-local IP address or pdu.local to access the PX3TS. See
(on page 170).
Tip: To configure a number of PX3TS devices quickly, see
Methods (on page 26).

Connecting a Mobile Device to PX3TS

Raritan's PDView is a free app that turns your iOS or Android mobile device into
a local display for PX3TS.
PDView is especially helpful when your PX3TS is not connected to the network
but you need to check the PX3TS status, retrieve its information, or change its
settings.
Requirements for using PDView:
•
PX3TS is running any post-3.0.0 firmware version.
•
If using an Android device, it must support USB "On-The-Go" (OTG).
•
An appropriate USB cable is required. For information, refer to Step B
below.
Step A: Download and install PDView
1. Visit either Apple App or Google Play Store.
Chapter 3: Initial Installation and Configuration
(on page 131).
Device Info (on page 155).
(on page 17).
Connecting the PX3TS to a
Initial Network Configuration via CLI
Login (on page 170).
Connecting a
(on
Login
Bulk Configuration
17