LEGRAND Raritan PX3TS User Manual page 414

Chapter 7: Using the Web Interface
394
Available Actions
The PX3TS comes with three built-in actions, which cannot be deleted. You can
create additional actions for responding to different events.
To test an action:
•
Click the Test button next to the Action. The action is triggered and you
can verify it.
Built-in actions:
•
System Event Log Action:
This action records the selected event in the internal log when the event
occurs.
•
System SNMP Notification Action:
This action sends SNMP notifications to one or multiple IP addresses after
the selected event occurs.
Note: No IP addresses are specified for this notification action by default so
you must enter IP addresses before applying this action to any event rule.
See Editing or Deleting a Rule/Action
the 'SNMP Notifications' section on the SNMP page will update the settings
of the System SNMP Notification Action, and vice versa. See
SNMP Settings (on page 340).
•
System Tamper Alarm:
This action causes the PX3TS to show the alarm for the Raritan tamper
sensor, if any, on the Dashboard page until a person acknowledges it. By
default, this action has been assigned to the built-in tamper detection
event rules. For information on acknowledging an alarm, see
Alarms (on page 190).
Actions you can create:
1. Choose Device Settings > Event Rules >
2. Click the Action field to select an action type from the list.
3. Below is the list of available actions.
(on page 429). Any changes made to
Configuring
Dashboard -
.